Pro-Fab EZ Lok Roof
Pro-Fab EZ Lok roof panels come in 4ft and 2ft widths. Panels consist of a 3 inch thick core of expanded polystyrene (EPS) foam with a textured .024 inch aluminum skin bonded to both sides. Each panel has a male and a female interlock on opposite edges. Panels are available cut to the foot in length. Varying snow loads and wind loads in different locations will affect roof spans. Mid-span beams are available to achieve longer spans or carry heavier snow loads. 6-inch thick roof panels are available as another way to achieve longer spans and accommodate heavier loads or as a way to improve R-value. R-value of the 3″ panel is approximately 12. This roof system is typically used for patio rooms or as an upgrade option in screen rooms or patio covers. Most rooms are built with low pitch (¾ inch/foot) single slope roofs. A gable roof is an option.
Structuroll Plus Each 12 inch wide, 3 inch deep .032″ aluminum roof pan has a flat bottom with 3 pencil ribs and square edges. Pans interlock with each other at the top of the 3″ tall leg. When interlocked and fastened, our roof pans form a flat ceiling. Pans are available in either smooth or embossed finish. Pans are available cut to the foot in length. This roof system is standard for stick framed screen rooms and patio covers. An optional drop-in insulation and cover sheet are available to make an insulated roof with a smooth top.
Roof and Trim Options
Pro-Fab roofs use extruded aluminum fascia and gutters. Skylights that are 2 foot wide and run the length of the roof panels are an option with our 3-inch Pro-Fab roofs. These skylights snap onto the formed edges of the Pro-Fab panels for a watertight seal, they are two layers of honeycomb polycarbonate with an airspace between them for insulation. This skylight is not transparent, meaning you can not look up and see the stars, but is translucent and disperses sunlight in many directions. An internal fan support and wire chase beam is available in either the 2 or 4-ft panels. Structuroll roofs use a roll formed fascia and gutter. Pro-fab roofs use extruded fascia and the three inch thick panels have a extruded gutter. Our standard downspout for either system is 3″x 4″.